- No products in the cart.
RPB-KT-2000-00 – Tides Marine Rudder Port Seal Type K for a 2 inch rudder stock.
This is a Direct Replacement for the stuffing box on a HATTERAS 2 inch rudder stock.
Tides Marine RPB TYPE-K units are used with certain flanged bronze ports having two mounting studs for the flax packing collar. They mount directly over the existing studs. They are available with and without a separate lower bearing insert. This insert installs from inside or outside the hull (depending on the application) and replaces the conventional marine bearing. TYPE-K units consist of a one piece UHMW plastic housing with a nitrile lip seal.Like all Tides Marine Rudder Port/Bearings, they eliminate the problems of metal-on-metal abrasion, electrolysis and corrosion. They are 100% watertight, require no maintenance and eliminate vibration resulting in quieter, smoother performance.
Available separately or as a kit
The Tides Marine RPB Type K was designed to be used with certain flanged, bronze rudder ports with two mounting studs to accept/adjust the flax packing collar. These units mount directly over the existing studs and are available with or without a lower bearing insert. This insert installs from outside the hull and usually replaces a conventional marine cutless bearing.
The Type K unit consists of a one-piece UHMW housing with a nitrile lip seal. The unit eliminates metal-on-metal contact and the associated problems of abrasion and electrolytic corrosion. They are 100% watertight and reduce rudder chatter and vibration resulting in quieter, smoother rudder system performance.
Tides Marine makes RPB Type K units to builder specifications. When placing an order, please specify the exact diameter of your rudder stock (.000″), the distance between the centers of the mounting studs, the stud size and the I.D. of the rudder port into which the unit will be mounted. Match this combination to one of the line items in the table on the Imperial or Metric size page. If your installation is not in this table, please contact Tides Marine for assistance.
If you are replacing a marine bearing, please provide the O.D. of the bearing and its length.
|Rudder Stock Diameter||Stud Centers||Stud Size||Lower Bearing||Barrel OD||Builder||Retaining Ring||Part Number||Buy Online|
|1 1/4||2 13/16||3/8||No||1.780||Bertram||206||RPB-K-1250-00||Buy Now|
|1 3/4||3 1/16||3/8||No||1.780||Bertram||250||RPB-K-1750-00||Buy Now|
|1.925||3 5/8||3/8||No||2.545||Bertram||287||RPB-K-1925-00||Buy Now|
|2||4 1/8||1/2||Yes||2.998||Viking||300||RPB-K-2000-01||Buy Now|
|2||4 3/16||1/2||Yes||2.998||Davis||300||RPB-K-2000-02||Buy Now|
|2.49||4 1/8||3/8||No||3.000||Bertram||350||RPB-K-2490-00||Buy Now|
|2 1/2||4 1/2||1/2||Yes||3.500||Hatteras||350||RPB-K-2500-00||Buy Now|
|2 1/2||5 1/4||1/2||Yes||3.495||Viking||350||RPB-K-2500-02||Buy Now|
The following is a description of the installation procedures associated with the RPB Type-K rudder seal. Installation instructions are included with each unit and should be followed closely.
Note: Before installing the rudder, insert the red installation hat into the lip seal. When rudder is in place, remove, invert and replace it on top of the Type-K unit to keep debris off the lip seal during use.
Complete Type-K Installation Guide may be downloaded HERE