SureSeal Adjustment Instructions
Initial Adjustments after Installation
A significant number of SureSeal assemblies get installed at a slight angle to the axis of the drive shaft.
This can result in premature leakage, often allowing leaks after the lip seal is changed.
As long as the shaft seal assembly has been in service for no more than 200 hours of run time, an adjustment should be the first step in attempting to correct a leak. An adjustment should also be performed any time a lip seal is replaced.
The adjustment is done by first loosening the hose clamps on the aft, or stern tube, end of the blue hose. Then move the assembly, shaft seal and articulated hose as a unit, fore and aft slightly until it feels like the shaft seal housing is properly centered on the drive shaft. Re-tighten aft hose clamps.
Contact us for more information on Tides Marine Products
Quality Marine Systems at a fair price....
it's just the beginning of the Tides Marine experience.
Tides Marine 3251 SW 13th Dr. Suite A Deerfield Beach, Fl 33442
Tel: (800) 420-0949 Tel: (954) 420-0949 Order Fax: (954) 420-0945 General Fax: (954) 420-5234
Copyright © 2011 Tides Marine, Inc. All Rights Reserved.